Conveyor Belt Deviation Reasons：
① The tensioning device may not be adjusted properly during installation;
② The force points on the left and right sides of the belt may be uneven during use, and one side is used for long-term cargo transportation, causing the belt to deviate to the long-term load-bearing side;
Conveyor Belt Deviation Solutions:
① Adjust the tensioning device to the appropriate degree as much as possible;
② When conveying goods, put the goods in the middle as much as possible;
Conveyor Belt Slippage Reasons:
① The tensioning device is too tight;
② The skin of the push roller is damaged;
③ Too much cargo is transported in the same batch;
④ There is dirt on the belt, causing the roller to slip;
Conveyor Belt Slippage Solutions:
① Adjust the tensioning device to an appropriate degree;
② Control the weight of the transported goods to a certain extent;
③ Clean the belt regularly to ensure the belt is clean;
Conveyor Belt Breakage And Damage Reasons:
① The transported goods contain sharp objects;
② The conveyor belt is unevenly stressed;
③ The belt is torn due to the jamming;
④ The belt becomes fragile and easy to break due to excessive high temperature;
Conveyor Belt Breakage And Damage Solutions:
① When conveying sharp objects, wrap up the sharp parts as much as possible;
② Belt deviation causes uneven force on the belt, and the belt deviation problem needs to be solved;
③ Pay attention to the use of the equipment to see if the equipment is stuck with packages, materials and other items;
④ Avoid using belt conveyors in places with extremely high temperatures, and you can replace them with other conveyors;
⑤ When the equipment breaks, you need to shut down the running equipment immediately;
Abnormal Noise In The Conveyor Reasons:
① When the roller is seriously eccentric;
② The two shafts of the coupling are different ;
③ Abnormal noise from the redirection roller and the driving roller;
④ Noise from the reducer;
Abnormal Noise In The Conveyor Solutions:
① Replace and repair the belt conveyor roller in time to avoid causing greater damage;
② Change the driving direction of the roller or replace the roller to eliminate or reduce the noise;
③ Adjust the relative position of the reducer of the lower belt conveyor to avoid damage to the reducer;
④ If the reducer anchor screws are loose, the center of the wheel is not correct or the wheel screws are loose, the gears are missing or worn out, or the reducer is short of oil, the parts should be repaired or replaced in time.
The Conveyor Belt Not Running Reasons：
① The motor loses power;
② The redirection roller is stuck or frozen;
③ The button is not reset after stopping on the spot;
④ The pull-wire switch or the deviation switch is not reset after actuation;
The Conveyor Belt Not Running Solutions:
① Replace the motor and choose a motor with a larger power;
② Clean the dirt regularly to avoid material jamming and other situations that cause the conveyor belt to not run;
③ Check whether the power supply voltage is normal, whether the drive motor circuit is normal, whether the switch has poor contact, and whether the motor is damaged;
Insufficient Conveyor Belt Tension Reasons:
① The friction between the belt and the roller is not enough;
② The tensioning roller is not tightened;
③ The motor Insufficient power;
Insufficient Conveyor Belt Tension Solutions:
① Adjust the position of both sides of the driving wheel or the driven wheel to balance the tension of the belt. If the adjustment is ineffective, reconnect it;
② Replace the belt regularly to increase the tension of the belt;
③ Increase the power of the motor to increase the belt tension;
Conveyor Belt Loose Reasons:
① Poor working environment;
② Excessive working time;
③ The tensioning device was not set properly during installation;
Conveyor Belt Loose Solutions:
① Control the working time of the machine and rotate the equipment;
② Try to tidy up the use environment as much as possible;
③ Adjust the tension of the belt and the traction roller.
